Anatomy Of A Toilet Bowl

When it gets to the top of the fill valve the toilet stops filling. The tank which sits up behind the bowl contains reserve water for refilling the bowl plus the devices for flushing clean water into the bowl and refilling the tank.

How To Repair A Toilet Learn Why How To Diy Home Tips

This keeps water from constantly flowing into your toilet bowl.

Anatomy of a toilet bowl. A toilet has two main partsthe tank and the bowl. The toilet flush valve which lets water gush into the bowl during the flush. Since the tank was situated above the bowl it relied partly on gravity to force water into the bowl to remove waste.

Squirts water into the bowl after the flush. Lid of the toilet tank. As the toilet flapper closes off the water to the bowl the toilet fill valve sometimes referred to as a ballcock begins to bring water back into the toilet tank to recharge for the next flush.

The main water jet aka siphon jet is usually at the bottom of the toilet bowl. First the bowl of the toilet is effectively mounted onto the floor via the bolts on the base of the toilet and the placement of a new toilet flange. Anatomy of a toilet.

As the water in the tank rises a float on the fill valve rises with it. A guide to understanding toilet plumbing. Next the connective hole for water flow is filled with the rubber gasket and accompanying watertight rings.

When a toilet is flushed water sitting in the tank rushes into and around these hollow chambers and then enters the bowl via water jets. Water flows into the tank from the supply line through the fill valve. Metal bar connected to the toilet handle.

As the water moves from the tank to the toilet bowl the flapper slowly sinks again to seat on the flush valve. To provide some perspective the gravity flush toilet worked by having the tank mounted to the wall above the toilet bowl. A chain allows a person to flush the toilet by pulling the chain to release water from the tank to the bowl.

Connects the trip level to the flapper valve. The force of the water pulls the water and waste youre flushing through the trap and into your sewer. When you flush the handle it pulls the trip lever or chain up.

The bowl holds water and connects to the drain for disposing of waste water and waste. When a toilet runs constantly or intermittently one of these valves is usually at fault. And the fill valve which lets water refill the tank after the flush.

There are really only two main toilet tank parts. How a toilet works anatomy of a toilet note the hollow area around the bowl. Parts of a toilet diagram.

At then end of the chain is the flapper so when you flush the flapper is lifted. Moves up and down along the toilet fill valve.

Toilet Seat Wikipedia